Home › Engine / Hybrid System › 2GD-FTV INTAKE / EXHAUST › EXHAUST PIPE(for Urea SCR System) › from 2016.03
RM3250E _51 Engine / Hybrid System _038009 2GD-FTV INTAKE / EXHAUST _0262587 EXHAUST PIPE(for Urea SCR System) A

2GD-FTV INTAKE / EXHAUST  EXHAUST PIPE(for Urea SCR System)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
A356209

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 17430 1.REMOVE TAILPIPE ASSEMBLY

a.

Remove the 2 bolts and 2 nuts.


b.

Disconnect the tailpipe assembly from the front exhaust pipe assembly and remove the gasket.


c.

for TSAM Made:

Remove the tailpipe assembly from the 3 exhaust pipe supports.


d.

for TMT Made:

Remove the tailpipe assembly from the 4 exhaust pipe supports.


Hide 89460B 3.REMOVE NITROGEN OXIDES SENSOR ASSEMBLY

Hide 51204 6.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for Manual Transmission)

Hide 7.SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 51204 8.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for Automatic Transmission)

Hide 23203A 9.REMOVE UREA INJECTOR SET

Hide 17410 10.REMOVE FRONT EXHAUST PIPE ASSEMBLY

NOTICE:
A380556

Do not hold the front exhaust pipe assembly at the location shown in the illustration. Otherwise, it may become deformed or damaged, adversely affecting its thermal insulation capabilities.


a.

Remove the No. 1 exhaust pipe support from the front exhaust pipe assembly.


b.

Remove the 2 bolts and 2 compression springs.


c.

Disconnect the front exhaust pipe assembly from the exhaust manifold converter sub-assembly and remove the gasket.