Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068615 ENGINE IMMOBILISER SYSTEM S

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


Engine Immobiliser System
DTC No. Detection Item DTC Output from Note Link
B2780 Push Switch / Key Unlock Warning Switch Malfunction Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


Click here
B2784 Antenna Coil Open / Short Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


Click here
B2793 Transponder Chip Malfunction Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


Click here
B2794 Unmatched Encryption Code Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


Click here
B2795 Unmatched Key Code Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


Click here
B2796 No Communication in Immobiliser System Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder


Click here
B2797 Communication Malfunction No. 1 Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder


Click here
B2798 Communication Malfunction No. 2 Transponder Key ECU Assembly
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder


Click here
B2799 Engine Immobiliser System Malfunction ECM
DTC Output Confirmation Operation

Either condition is met:

·

Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal*2 or clutch pedal*3 depressed, turn the ignition switch to ON). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).

·

10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).



Click here
B279A Theft Deterrent System Communication Line High Fixation ECM
DTC Output Confirmation Operation

Turn the ignition switch to ON and wait 6 seconds.


Click here
B279C Theft Deterrent System Presence Detection ECM
DTC Output Confirmation Operation

Check for DTCs.


Click here