Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- If the auto up/down function does not operate, the cause may be one or more of the following:
- The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
- The rear power window regulator switch has a malfunction.
- The Hall IC in the power window regulator motor has a malfunction.
- There is an open or short in the wiring between the rear power window regulator switch and rear power window regulator motor.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Since the power window control system has functions that use LIN communication, first confirm that there is no malfunction in the communication system by inspecting the LIN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC B2311 is output
B
DTC B2312 is output
C
DTC B2313 is output
D
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. CHECK MANUAL UP/DOWN FUNCTION (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH) |
Check that the manual up/down function using the rear power window regulator switch can operate the rear power window regulator motor (Click here).
- OK:
- Manual up/down function operates.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (REAR POWER WINDOW REGULATOR SWITCH) |
Use the Data List to check if the rear power window regulator is functioning properly (Click here).
RL-Door Motor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
RL Door P/W Auto SW
Rear power window LH auto up/down signal / ON or OFF
ON: Rear power window LH auto up/down switch operated
OFF: Rear power window LH switch not operated
-
- OK:
- On tester screen, item changes between ON and OFF according to above chart.
|
|
||||
| OK | ||
| ||
| 4. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH |
Remove the rear power window regulator switch (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
8 (AUTO) - 1 (GND)
Auto up/down operation
Below 1 Ω
8 (AUTO) - 1 (GND)
Not operated
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH LH - REAR POWER WINDOW REGULATOR MOTOR LH AND BODY GROUND) |
Disconnect the M2 rear power window regulator switch connector.
Disconnect the M4 power window regulator motor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
M2-8 (AUTO) - M4-4 (AUTO)
Always
Below 1 Ω
M2 (GND) - Body ground
Always
Below 1 Ω
M2-8 (AUTO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
