1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
52129B
2.REMOVE FRONT BUMPER LOWER COVER
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
53736
5.REMOVE FRONT FENDER APRON SEAL RH
53736B
6.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH
53292A
7.REMOVE UPPER RADIATOR SUPPORT SEAL
87452A
8.REMOVE FRONT HEATER BRACKET (for Cold Area Specification Vehicles)
16361A
9.REMOVE FAN AND GENERATOR V BELT
17881
10.REMOVE NO. 1 AIR CLEANER HOSE
17705
11.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
12.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
13.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
17341F
14.REMOVE NO. 1 AIR HOSE
17275A
15.REMOVE COMPRESSOR OUTLET ELBOW
87120G
16.REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY (for Cold Area Specification Vehicles)
87101
17.REMOVE VISCOUS HEATER NO. 1 BRACKET SUB-ASSEMBLY (for Cold Area Specification Vehicles)
88320
18.DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)
12511C
19.REMOVE GENERATOR BRACKET
27020
20.REMOVE GENERATOR ASSEMBLY
88431
21.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
12229
22.REMOVE VENTILATION PIPE
11409
23.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
16572D
24.DISCONNECT NO. 2 RADIATOR HOSE
16264D
25.DISCONNECT NO. 2 WATER BY-PASS HOSE
Disconnect the No. 2 water by-pass hose from the water inlet.
16321
26.REMOVE WATER INLET
for Automatic Transmission:
Remove the 2 bolts from the oil cooler tube clamp and bracket.
Remove the 3 bolts and inlet.
16331A
27.REMOVE THERMOSTAT
Remove the thermostat.
Remove the gasket from the thermostat.