Home › Drivetrain › RA61F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION ASSEMBLY (for 1GR-FE)
RM27T0E _52 Drivetrain _053701 RA61F MANUAL TRANSMISSION / TRANSAXLE _0260819 MANUAL TRANSMISSION ASSEMBLY(for 1GR-FE) A

RA61F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION ASSEMBLY(for 1GR-FE)  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 58286 3.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT

C215582

a.

Remove the 4 screws, 2 clips and No. 1 shift and select lever boot.


Hide 33530F 4.REMOVE SHIFT LEVER ASSEMBLY

a.
F051062

Detach the shift lever cap boot from the manual transmission.


b.

Cover the shift lever cap with a cloth.


c.
C328999E01
1.872,0.769 2.068,0.922 0.196,0.153 10 *a 1.735,2.328 1.930,2.481 0.196,0.153 10 *b 1.114,3.197 1.310,3.350 0.196,0.153 10 *c 2.004,0.474 2.248,0.23 2.248,0.23 2.411,0.23 false 2.474,0.136 2.670,0.289 0.196,0.153 10 *1

While pressing down on the shift lever cap, turn it counterclockwise, and then pull to remove the shift lever assembly.

Text in Illustration
*1 Shift Lever Cap
*a Press Down
*b Counterclockwise
*c Pull out


Hide 5.DRAIN MANUAL TRANSMISSION OIL

a.

Remove the drain plug and gasket, and then drain the manual transmission oil.


b.

Install a new gasket and the drain plug.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 37117 9.REMOVE PROPELLER SHAFT HEAT INSULATOR

C215584

a.

Remove the 2 bolts and propeller shaft heat insulator.


Hide 36179 10.REMOVE TRANSFER CASE LOWER PROTECTOR

a.

Remove the 4 bolts and transfer case lower protector.


Hide 37140 11.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 37110 12.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 28100 13.REMOVE STARTER ASSEMBLY

Hide 31121 14.REMOVE NO. 1 CLUTCH HOUSING COVER

Hide 31470 15.REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 31490 16.REMOVE CLUTCH ACCUMULATOR ASSEMBLY

Hide 31482 17.REMOVE CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE

a.
C331843

Remove the 3 nut, clip and clutch release cylinder to flexible hose tube.


Hide 18.SUPPORT MANUAL TRANSMISSION WITH TRANSFER

a.

Support the manual transmission with a transmission jack.


Hide 51226A 19.REMOVE FRONT SUSPENSION MEMBER BRACKET LH

C215587

a.

Remove the 4 bolts and front suspension member bracket LH.


Hide 51225B 20.REMOVE FRONT SUSPENSION MEMBER BRACKET RH

C215588

a.

Remove the 4 bolts and front suspension member bracket RH.


Hide 51204 21.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

a.

Support the rear side of the manual transmission with a support stand.


b.
C215589

Remove the 4 bolts from the No. 3 frame crossmember sub-assembly.


c.
C215590

Remove the 4 nuts, 4 bolts and No. 3 frame crossmember sub-assembly.


Hide 12391 22.REMOVE FRONT ENGINE MOUNTING INSULATOR RH

a.
C332736

Remove the bolt and front engine mounting insulator RH.


Hide 12371 23.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

a.
C332737

Remove the 4 bolts and rear No. 1 engine mounting insulator from the manual transmission.


Hide 24.DISCONNECT WIRE HARNESS

a.
C215592

Disconnect the 2 connectors.


b.

Detach the 7 clamps.


c.

Disconnect the back-up light switch connector.


d.

Remove the bolt and disconnect the wire harness.


Hide 36407 25.DISCONNECT TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY

a.
C215593

Detach the breather hose clamp.


b.

Disconnect the 4 breather hoses from the bracket and clutch housing.


c.

Disconnect the 2 breather hoses from the transfer adapter.


Hide 26.REMOVE MANUAL TRANSMISSION WITH TRANSFER

a.

Using a transmission jack, support the transmission.


b.

Remove the support stand from the transmission.


c.

Remove the 9 bolts.


d.
C215594

Remove the manual transmission with transfer.


Hide 33107 27.REMOVE TRANSMISSION UPPER COVER SUB-ASSEMBLY

C215595

a.

Remove the 2 bolts and transmission upper cover sub-assembly.