1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67920
3.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)
62112
4.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
55318C
5.REMOVE INSTRUMENT SIDE PANEL LH (for LHD)
55471A
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55476C
8.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
67910
9.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
62111C
10.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
55317A
11.REMOVE INSTRUMENT SIDE PANEL RH (for RHD)
55607
12.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55480D
13.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55045
14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
73900
15.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
84010A
16.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
55420A
17.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Navigation System)
55522B
18.REMOVE RADIO TUNER OPENING COVER (w/o Audio)
86120
19.REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
86431
20.REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY (w/ Navigation System)
89343C
21.REMOVE NO. 1 CLEARANCE WARNING BUZZER
Disconnect the connector.
Detach the clamp and remove the No. 1 clearance warning buzzer.