1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE FRONT SEAT ASSEMBLY (for RHD)
for Manual Seat:
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL).
for Walk in Seat:
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Walk in Seat Type)>REMOVAL).
58810J
3.REMOVE CONSOLE BOX ASSEMBLY (for RHD)
for Automatic Transmission:
Remove the console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Automatic Transmission)>REMOVAL).
for Manual Transmission:
Remove the console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>REMOVAL).
w/ Refrigerated Cool Box:
Remove the console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>REMOVAL).
4.REMOVE REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)
for LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type LH Side)>REMOVAL).
for RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)>REMOVAL).
67920
5.REMOVE DOOR SCUFF PLATE ASSEMBLY LH
67910
6.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
64910M
7.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
58649C
8.REMOVE MAT SET PLATE COVER
58574A
9.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
62538E
10.REMOVE QUARTER TRIM COVER HOLE LH
58570C
11.REMOVE REAR FLOOR CARPET ASSEMBLY
64725D
12.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64937A
13.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
14.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
62596D
15.REMOVE QUARTER TRIM POCKET TRAY
73233
16.REMOVE OUTER LAP BELT ANCHOR COVER
64740C
17.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
62640P
18.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
77306
19.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
58510D
20.REMOVE FRONT FLOOR CARPET ASSEMBLY
for LHD:
Detach the 4 clamps and fold back the front floor carpet from the floor carpet hooks.
for RHD:
Detach the 8 clamps and fold back the front floor carpet from the floor carpet hooks.
77035
21.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Turn the cable counterclockwise and remove the cable from the retainer.
Turn the lock retainer counterclockwise and remove the lock retainer.
for LHD:
Using a clip remover, detach the clamp labeled <A>.
Detach the 11 clamps and remove the fuel lid lock control cable.
for RHD:
Using a clip remover, detach the 3 clamps labeled <A>.
Detach the 11 clamps and remove the fuel lid lock control cable.