Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM › 2017.08–2021.06
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260886 KINETIC DYNAMIC SUSPENSION SYSTEM T

SUSPENSION CONTROL  KINETIC DYNAMIC SUSPENSION SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.

Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Kinetic Dynamic Suspension System
Symptom Suspected Area See page
Kinetic dynamic suspension system DTC cannot be output (When using intelligent tester) CAN communication system (Click here)
Harness or connector (power source of stabilizer control ECU) (Click here)
Stabilizer control ECU (Click here)
Kinetic dynamic suspension system DTC cannot be output (When not using intelligent tester) CAN communication system (Click here)
Harness or connector (power source of stabilizer control ECU) (Click here)
Stabilizer control ECU (Click here)
Combination meter (Click here)
KDSS indicator light does not come on CAN communication system (Click here)
Combination meter (Click here)
Vehicle is tilted Stabilizer control solenoid valve (Click here)
Fluid leakage (Click here)
Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid) (Click here)
Roll is not controlled when driving Brake control system (Click here)
Stabilizer control solenoid valve (Click here)
Fluid leakage (Click here)
Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid) (Click here)
Accumulator pressure sensor (Click here)