88566R
1.INSTALL REAR ROOF NO. 1 AIR DUCT
Install the rear roof No. 1 air duct with the 4 clips.
88566S
2.INSTALL REAR ROOF NO. 2 AIR DUCT
Install the rear roof No. 2 air duct with the clip.
88566T
3.INSTALL REAR ROOF NO. 3 AIR DUCT
Install the rear roof No. 3 air duct with the clip.
88566U
4.INSTALL REAR ROOF NO. 4 AIR DUCT
Install the rear roof No. 4 air duct with the clip.
88566V
5.INSTALL REAR ROOF NO. 5 AIR DUCT
Install the rear roof No. 5 air duct with the clip.
87030A
6.INSTALL REAR COOLING UNIT ASSEMBLY
Install the rear cooling unit assembly to the vehicle with the 5 bolts.
Connect the 3 connectors.
Attach the 3 clamps.
87217D
7.INSTALL REAR SIDE NO. 1 AIR DUCT
Insert the upper part of the rear side No. 1 air duct into the roof side duct and, using that point as a pivot point, swing the rear side No. 1 air duct into place and install it to the rear cooling unit.
Attach the 2 claws to install the cooler plate.
87217F
8.INSTALL REAR SIDE NO. 3 AIR DUCT
Install the rear side No. 3 air duct with the 2 clips.
87217E
9.INSTALL REAR SIDE NO. 2 AIR DUCT
Install the rear side No. 2 air duct with the 2 clips and attach the clamp.
62170A
10.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure as for the curtain shield airbag assembly LH.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CURTAIN SHIELD AIRBAG ASSEMBLY>INSTALLATION
88710A
11.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
Remove the attached vinyl tape from the pipe.
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioning tube and accessory assembly.
| Refrigerant | Compressor Oil |
|---|---|
| HFC-134a (R134a) | ND-OIL 8 or equivalent |
| HFO-1234yf (R1234yf) | ND-OIL 12 or equivalent |
Install the 2 O-rings to the air conditioning tube and accessory assembly.
Connect the air conditioning tube and accessory assembly.
Install the bolt.
Connect the heater water inlet hose and heater water outlet hose.
Using pliers, grip the claws of the clips and slide the 2 clips.
62630P
12.INSTALL REAR QUARTER TRIM PANEL ASSEMBLY RH
64730B
13.INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
74603C
14.INSTALL ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)
74617A
15.INSTALL ASSIST GRIP PLUG (w/ Rear No. 2 Seat)
64712F
16.INSTALL FRONT DECK SIDE TRIM COVER RH (w/ Tonneau Cover)
64937A
17.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64725D
18.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
73233A
19.INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
58570C
20.INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)
57411D
21.INSTALL FLOOR SIDE RAIL RH (w/ Deck Rail)
57412C
22.INSTALL FLOOR SIDE RAIL LH (w/ Deck Rail)
58574A
23.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
58401A
24.INSTALL NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
64717A
25.INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)
64910M
26.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
73233
27.INSTALL OUTER LAP BELT ANCHOR COVER
62331C
28.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
67917C
29.INSTALL REAR DOOR SCUFF PLATE RH
67933
30.INSTALL INSIDE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
58371F
31.INSTALL NO. 1 REAR FLOOR STEP COVER (w/ Rear No. 2 Seat)
32.INSTALL REAR NO. 1 SEATBACK ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
for 60/40 Split Double-folding Seat Type RH Side:
33.INSTALL REAR NO. 2 SEAT ASSEMBLY
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type LH Side)>INSTALLATION
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>INSTALLATION
for Face to Face Seat Type:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>INSTALLATION
34.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
35.ADD ENGINE COOLANT
for 1GR-FE:
Click hereEngine / Hybrid System>1GR-FE (COOLING)>COOLANT>REPLACEMENT
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE (COOLING)>COOLANT>REPLACEMENT
for 5L-E:
Click hereEngine / Hybrid System>5L-E (COOLING)>COOLANT>REPLACEMENT
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV (COOLING)>COOLANT>REPLACEMENT
36.CHARGE REFRIGERANT
for HFC-134a (R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf (R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
37.WARM UP ENGINE
for HFC-134a (R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf (R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
38.INSPECT FOR ENGINE COOLANT LEAKS
for 1GR-FE:
Click hereEngine / Hybrid System>1GR-FE (COOLING)>COOLANT>REPLACEMENT
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE (COOLING)>COOLANT>REPLACEMENT
for 5L-E:
Click hereEngine / Hybrid System>5L-E (COOLING)>COOLANT>REPLACEMENT
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV (COOLING)>COOLANT>REPLACEMENT
39.CHECK FOR REFRIGERANT GAS LEAK
for HFC-134a (R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf (R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT(for HFO-1234yf(R1234yf))>REPLACEMENT
40. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
41.CHECK SRS WARNING LIGHT
53292A
42.INSTALL UPPER RADIATOR SUPPORT SEAL