Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
- If the auto up/down function does not operate, the cause may be one or more of the following:
- The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
- The power window regulator switch has a malfunction.
- The Hall-IC in the power window regulator motor has a malfunction.
- There is an open or short in the wiring between the rear power window regulator switch RH and the power window regulator motor.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Check for DTCs (Click here).
Result: Result
Proceed to
DTC is not output
A
B2311 is output
B
B2312 is output
C
B2313 is output
D
LIN communication system DTCs are output
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. CHECK MANUAL UP/DOWN FUNCTION (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH) |
Check that the manual up/down function using the rear power window regulator switch RH can operate the rear door power window RH (Click here).
- OK:
- Manual up/down function operates.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (REAR POWER WINDOW REGULATOR MOTOR RH) |
Use the Data List to check if the power window regulator motor is functioning properly (Click here).
RR-Door Motor Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
RR Door P/W Auto SW
Rear power window RH auto up/down signal / ON or OFF
ON: Rear power window RH auto up/down switch operated
OFF: Rear power window RH switch not operated
-
- OK:
- The display changes according to operation of the rear power window switch RH.
|
|
||||
| OK | ||
| ||
| 4. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH - REAR POWER WINDOW REGULATOR MOTOR RH) |
Disconnect the J3 switch connector.

Disconnect the J4 motor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
J3-8 (AUTO) - J4-4 (AUTO)
Always
Below 1 Ω
J3-8 (AUTO) or J4-4 (AUTO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 5. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH |
![]() ![]() |
Remove the rear power window regulator switch (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
J3-8 (AUTO) - J3-1 (GND)
Auto up/down operation
Below 1 Ω
|
|
||||
| OK | ||
| ||

