Home › Engine / Hybrid System › 3UR-FE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM2660E _51 Engine / Hybrid System _052777 3UR-FE ENGINE MECHANICAL _0255047 FRONT CRANKSHAFT OIL SEAL A

3UR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 53806 1.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 16571C 6.REMOVE NO. 1 RADIATOR HOSE

Hide 83520 8.REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 88320 9.DISCONNECT COOLER COMPRESSOR ASSEMBLY

Hide 16207 10.DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY

a.
A163800

Remove the 3 bolts and disconnect the 2 water by-pass hoses from the oil cooler.


Hide 13521A 14.REMOVE CRANKSHAFT TIMING GEAR KEY

a.
A163993

Remove the crankshaft timing gear key from the crankshaft.


Hide 11301C 15.REMOVE FRONT CRANKSHAFT OIL SEAL

a.
A163774

Using a screwdriver, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.


HINT:

Tape the screwdriver tip before use.