Home › Engine / Hybrid System › 1GR-FE (ENGINE MECHANICAL) › ENGINE UNIT
RM2660E _51 Engine / Hybrid System _052778 1GR-FE ENGINE MECHANICAL _0255061 ENGINE UNIT A

1GR-FE ENGINE MECHANICAL  ENGINE UNIT  INSTALLATION  


PROCEDURE

Hide 13453 1.INSTALL FLYWHEEL RING GEAR (for Manual Transmission)

a.
A177670E02
2.707,0.781 2.889,0.952 0.182,0.171 10 *3 0.459,1.081 0.647,1.267 0.188,0.186 10 *2 0.341,0.483 0.536,0.653 0.195,0.170 10 *1 2.117,1.13 2.525,0.866 false 2.521,0.866 2.679,0.866 false 1.378,0.278 0.794,0.57 false 0.798,0.57 0.562,0.57 false 1.407,0.461 0.888,1.169 false 0.892,1.168 0.671,1.168 false

Using a torch, heat the ring gear evenly to approximately 200°C (392°F).

Text in Illustration
*1 Chamfer
*2 Ring Gear
*3 Flywheel

NOTICE:

Be careful not to overheat the ring gear.



b.

Using a brass bar, tap the ring gear onto the flywheel with its chamfered gear teeth facing the block.

NOTICE:

After installing, allow the ring gear to cool before handling.



Hide 12311 2.INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET RH

a.

Install the front No. 1 engine mounting bracket RH with the 4 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 12315 3.INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH

a.

Install the front No. 1 engine mounting bracket LH with the 3 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 11452 4.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 16620 5.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

Hide 16604 6.INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

Hide 16603 7.INSTALL NO. 1 IDLER PULLEY SUB-ASSEMBLY

Hide 16206 8.INSTALL WATER BY-PASS PIPE SUB-ASSEMBLY

Hide 23250 10.INSTALL FUEL INJECTOR ASSEMBLY

Hide 23807 11.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 12.INSTALL FUEL PIPE SUB-ASSEMBLY

a.

Install the No. 1 fuel pipe and No. 2 fuel pipe with the 2 bolts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


b.

Hide 25702B 14.INSTALL NO. 2 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)

Hide 25701B 15.INSTALL NO. 1 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)

Hide 16.INSTALL HEATER WATER HOSE ASSEMBLY

a.

Install the heater water hose assembly and connect the 2 hoses with the 2 bolts.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 17.INSTALL ENGINE WIRE