16400
1.INSTALL RADIATOR ASSEMBLY
Set the radiator bracket hooks to the radiator support holes.
Install the radiator with the 4 bolts.
Connect the 2 oil cooler hoses.
16711
2.INSTALL FAN SHROUD
Install the fan pulley.
Place the shroud together with the coupling fan between the radiator and engine.
Be careful not to damage the radiator core.
Temporarily install the fluid coupling fan to the fluid coupling bracket with the 4 nuts. Tighten the nuts as much as possible by hand.
Attach the claws of the shroud to the radiator as shown in the illustration.
Install the shroud with the 2 bolts.
Connect the oil cooler tube to the fan shroud with the 2 bolts.
Pass the hose through the flexible hose clamp and close the clamp as shown in the illustration.
Connect the reservoir hose to the upper radiator tank.
Install the fan and generator V belt (See page Engine / Hybrid System>3UR-FE (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION).
Tighten the 4 nuts of the fluid coupling fan.
16572D
3.INSTALL NO. 2 RADIATOR HOSE
16571C
4.INSTALL NO. 1 RADIATOR HOSE
17880
5.INSTALL AIR CLEANER HOSE ASSEMBLY
11209
6.INSTALL V-BANK COVER SUB-ASSEMBLY
7.ADD ENGINE COOLANT
8.INSPECT FOR COOLANT LEAK
51405A
9.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
53294C
10.INSTALL RADIATOR SIDE DEFLECTOR LH
Install the radiator side deflector LH with the 4 clips.
32917
11.INSTALL TRANSMISSION OIL COOLER AIR DUCT