Home › Engine / Hybrid System › 1VD-FTV (COOLING) › THERMOSTAT › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052795 1VD-FTV COOLING _0255199 THERMOSTAT A

1VD-FTV COOLING  THERMOSTAT  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


a.

Disconnect the cables from the negative (-) main battery and sub-battery terminals.


Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 4.REMOVE FRONT WHEEL RH

Hide 53736G 5.REMOVE FRONT FENDER APRON SEAL FRONT RH

Hide 53806 6.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 7.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 8.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 82113 10.REMOVE NO. 3 ENGINE ROOM WIRE

a.

Disconnect the 4 wire harness clamps.


b.

Remove the 2 nuts and No. 3 engine room wire.

A174837


Hide 12601E 11.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)

Hide 44360 15.REMOVE VANE PUMP OIL RESERVOIR ASSEMBLY

a.
A177428

Insert a screwdriver between the reservoir and oil reservoir bracket, push the claw, and then disconnect the reservoir by pulling it upwards.


Hide 44369A 16.REMOVE NO. 1 OIL RESERVOIR BRACKET

a.
A184319

Remove the 2 bolts and bracket.


Hide 16470 17.REMOVE RADIATOR RESERVOIR ASSEMBLY

a.
A174735

Disconnect the 2 hoses.


b.

Remove the 3 bolts and radiator reservoir.


Hide 44310 18.REMOVE VANE PUMP ASSEMBLY

a.
C172309

Remove the 2 nuts and vane pump.


b.

Remove the O-ring from the vane pump.


Hide 16571C 19.DISCONNECT NO. 1 RADIATOR HOSE

Hide 16572D 20.DISCONNECT NO. 2 RADIATOR HOSE

Hide 21.REMOVE V-RIBBED BELT (w/ Viscous Heater)

Hide 22.REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)

Hide 23.REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)

Hide 32942 25.REMOVE OIL COOLER TUBE (for Automatic Transmission)

Hide 16711 26.REMOVE FAN SHROUD WITH FAN

a.
A161930

Loosen the 4 nuts holding the fluid coupling fan.


b.
A177427

Remove the 2 bolts holding the fan shroud.


c.
A179253

Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.


Hide 16371 27.REMOVE FAN PULLEY

Hide 87208 28.REMOVE HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)

a.
A179255

Remove the 4 bolts and disconnect the heater water pipe from the viscous heater with magnet clutch.


Hide 87120G 29.REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY (w/ Viscous Heater)

Hide 30.REMOVE NO. 1 IDLER PULLEY BRACKET (w/ Viscous Heater)

a.
A177432

Remove the bolt and No. 1 idler pulley bracket.


Hide 16321 31.REMOVE WATER INLET

a.
A174815

Disconnect the No. 2 oil cooler hose from the water pump and clamp.


b.
A174816

Remove the 4 bolts and water inlet.


Hide 16331A 32.REMOVE THERMOSTAT

a.

Remove the thermostat.


b.

Remove the gasket from the thermostat.