Home › Vehicle Interior › HEATING / AIR CONDITIONING › HEATER WATER PUMP (w/ Viscous Heater)
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255679 HEATER WATER PUMP(w/ Viscous Heater) A

HEATING / AIR CONDITIONING  HEATER WATER PUMP(w/ Viscous Heater)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53806 3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53292A 7.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 82113 8.REMOVE NO. 3 ENGINE ROOM WIRE

Hide 12601E 9.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17705 10.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A174698

Loosen the hose clamp.


b.

Disconnect the connector and detach the wire harness clamp.


c.

Detach the 4 clamps and remove the air cleaner cap.


Hide 17881 11.REMOVE NO. 1 AIR CLEANER HOSE

a.
A174699

Loosen the hose clamp and remove the No. 1 air cleaner hose.


Hide 17861 12.REMOVE INTAKE AIR CONNECTOR

A174749

a.

Disconnect the 2 connectors from the viscous heater and water temperature sensor.


b.

Using a clip remover, detach the 3 wire harness clamps.


c.
A174710

Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.


Hide 44360 14.REMOVE VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 16571C 16.REMOVE NO. 1 RADIATOR HOSE

Hide 16572D 17.REMOVE NO. 2 RADIATOR HOSE

Hide 15777 18.REMOVE OIL COOLER HOSE (w/ Air Cooled Transmission Oil Cooler)

Hide 16470 20.REMOVE RADIATOR RESERVE TANK ASSEMBLY

Hide 16400 21.REMOVE RADIATOR ASSEMBLY

a.

Remove the radiator assembly (See page Engine / Hybrid System>1VD-FTV (COOLING)>RADIATOR>REMOVAL).


Hide 16630H 22.REMOVE IDLER PULLEY ASSEMBLY

E154424

a.

Remove the 2 bolts and 2 idler pulleys.


Hide 87120G 23.REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY

E154426

a.

Disconnect the connector and detach the clamp.


b.

Using pliers, grip the claws of the clips and slide the 2 clips.


c.

Disconnect the 2 heater hoses.


d.

Remove the 2 bolts and heater assembly.


Hide 24.REMOVE IDLER PULLEY BRACKET

E154427

a.

Remove the bolt and bracket.


Hide 25.REMOVE IDLER PULLEY BRACKET (for Belt Tension Side)

E154425

a.

Remove the 3 bolts and bracket.