Home › Engine / Hybrid System › 3UR-FE (LUBRICATION) › ENGINE OIL COOLER
RM2660E _51 Engine / Hybrid System _052796 3UR-FE LUBRICATION _0255206 ENGINE OIL COOLER A

3UR-FE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15788 1.INSTALL OIL COOLER SPACER

a.

Apply a light coat of engine oil to a new gasket.


b.

Install the gasket to the oil cooler spacer.


c.

Install the oil cooler spacer to the oil filter bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 15710 2.INSTALL OIL COOLER ASSEMBLY

a.

Apply a light coat of engine oil to 2 new O-rings.


b.

Install the 2 O-rings to the oil cooler.


c.

Install the oil cooler with the 5 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 15671 3.INSTALL OIL FILTER BRACKET

a.

Apply a light coat of engine oil to 2 new O-rings.


b.

Install the 2 O-rings to the timing chain cover.


c.

Install the oil filter bracket with the 2 nuts and 2 bolts.

Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)


Hide 15781 4.INSTALL NO. 1 OIL COOLER BRACKET

a.

Connect the ground wire to the cylinder block.


b.

Install the oil cooler bracket with the 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 16207 5.INSTALL NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY

a.

Connect the 4 hoses.


b.

Install the water by-pass hose with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88320 6.CONNECT COOLER COMPRESSOR ASSEMBLY

Hide 83520 7.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 51405A 16.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 17.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 18.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH