Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for LHD) › from 2015.08
RM2660E _57 Power Source / Network _052837 NETWORKING _0255532 NETWORK GATEWAY ECU(for LHD) A

NETWORKING  NETWORK GATEWAY ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55448A 3.REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

Hide 55402C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55607 7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55476A 10.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55443D 11.REMOVE INSTRUMENT PANEL BOX DOOR KNOB

Hide 55433B 12.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 85940 13.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY

Hide 82731A 14.REMOVE COWL SIDE JUNCTION BLOCK RH

a.
E333989

Disconnect the 5 connectors.


b.
E333990

Remove the screw and 2 nuts and pull out the cowl side junction block RH.


c.
E333991

Detach the back side of the wire harness clamp and disconnect the 2 connectors.


Hide 89111 15.REMOVE NETWORK GATEWAY ECU

a.
E333992

Remove the bolt and network gateway ECU.