Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
48826D
1.REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
48860D
2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
3.REMOVE FRONT WHEEL
4.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
43512
5.REMOVE FRONT DISC
43502D
6.REMOVE FRONT AXLE HUB BOLT LH
Using SST and a screwdriver or equivalent to hold the axle hub, remove the front axle hub bolt.
Do not damage the threads of the hub bolt.
43502D
7.INSTALL FRONT AXLE HUB BOLT LH
Temporarily install a washer and hub nut to a new hub bolt as shown in the illustration.
Install a hub nut to prevent damage to the hub bolt.
Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.
Remove the washer and hub nut.
Do not damage the threads of the hub bolt.
8.INSPECT FRONT AXLE HUB BEARING LOOSENESS
9.INSPECT FRONT AXLE HUB RUNOUT
43512
10.INSTALL FRONT DISC
11.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
12.INSTALL FRONT WHEEL
13.MEASURE VEHICLE HEIGHT (w/ KDSS)
48860D
14.CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
48826D
15.INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)