Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
48069
1.TEMPORARILY INSTALL FRONT NO. 1 SUSPENSION ARM LOWER SUB-ASSEMBLY LH
Temporarily install the lower suspension arm, camber adjusting cam, No. 2 camber adjusting cam, No. 2 suspension toe adjusting plate, toe adjusting cam and washer with the bolt and nut.
Align the matchmarks on the No. 2 camber adjusting cam and No. 2 suspension toe adjusting plate with the matchmarks on the vehicle body. Tighten the bolt and nut.
The bolt and nut will be tightened to the torque specification in the "Tighten Front No. 1 Suspension Arm Lower Sub-assembly LH" procedure.
48626
2.CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
Connect the attachment to the steering knuckle with the 2 bolts.
3.CONNECT FRONT SHOCK ABSORBER WITH COIL SPRING LH
Connect the shock absorber with the bolt and nut.
48820B
4.TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY RH
48810
5.TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY LH (w/ KDSS)
48810
6.TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY LH (w/o KDSS)
48829A
7.TIGHTEN FRONT NO. 1 STABILIZER BRACKET LH
48824A
8.TIGHTEN FRONT NO. 1 STABILIZER BRACKET RH
51405A
9.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
53806
10.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
11.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
12.STABILIZE SUSPENSION
48069
13.TIGHTEN FRONT NO. 1 SUSPENSION ARM LOWER SUB-ASSEMBLY LH
Tighten the bolt and nut.
Perform this procedure with all 4 wheels on the ground.
14.TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
Tighten the nut.
Perform this procedure with all 4 wheels on the ground.
48810
15.TIGHTEN FRONT STABILIZER LINK ASSEMBLY LH (w/ KDSS)
48810
16.TIGHTEN FRONT STABILIZER LINK ASSEMBLY LH (w/o KDSS)
48820B
17.TIGHTEN FRONT STABILIZER LINK ASSEMBLY RH
18.MEASURE VEHICLE HEIGHT (w/ KDSS)
48860D
19.CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
48826D
20.INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
21.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Inspect and adjust the front wheel alignment (See page Suspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT).
22.ADJUST HEADLIGHT ASSEMBLY
for Standard:
Adjust the headlight (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Halogen Headlight)>ADJUSTMENT).
for HID Headlight:
Adjust the headlight (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for HID Headlight)>ADJUSTMENT).