Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2014.08–2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255416 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  Skid Control Buzzer Circuit  


DESCRIPTION

The skid control ECU (master cylinder solenoid) is connected to the combination meter via CAN communication.

The combination meter has a built-in buzzer.

WIRING DIAGRAM

C230884E06
5.387,1.288 5.710,1.444 0.323,0.156 10 A24 5.387,1.484 7.048,1.941 1.661,0.457 10 Skid Control ECU (Master Cylinder Solenoid) 0.605,1.762 0.881,1.955 0.276,0.193 10 E7 0.605,1.972 2.742,2.156 2.137,0.184 10 Combination Meter Assembly 1.025,0.905 1.579,1.107 0.554,0.202 10 Buzzer 0.904,2.399 2.856,2.583 1.952,0.184 10 : CAN Communication System

CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK CAN COMMUNICATION LINE

A

2.PERFORM ACTIVE TEST USING GTS (BUZZER)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

C

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.PERFORM ACTIVE TEST USING GTS (BUZZER)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Buzzer Buzzer ON/OFF The buzzer can be heard.


f.

When performing the Buzzer Active Test, check Buzzer in the Data List.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Buzzer Buzzer/ ON or OFF ON: Buzzer on
OFF: Buzzer off
The combination meter has a built-in buzzer.

Result
Result Proceed to
Data List Display Data List Display when Performing Active Test ON/OFF Operation
ON Changes between ON and OFF A
Does not change between ON and OFF B
OFF Changes between ON and OFF A
Does not change between ON and OFF B



A

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B

3.INSPECT COMBINATION METER ASSEMBLY
3.INSPECT COMBINATION METER ASSEMBLY
a.

Inspect the combination meter (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

Result
Result Proceed to
NG (w/ Multi-information Display) A
NG (w/o Multi-information Display) B
OK (for LHD) C
OK (for RHD) D



A

B

C

D