Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1VD-FTV without DPF) › 2014.08–2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255438 VANE PUMP(for 1VD-FTV without DPF) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1VD-FTV without DPF)  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY

a.
C178174

Coat a new O-ring with power steering fluid and install it to the vane pump.


b.

Install the vane pump with the 2 nuts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C179802

Install a new gasket to the pressure feed tube.


b.

Install the pressure feed tube and union with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the tube touches the vane pump body as shown in the illustration before tightening the bolt.



Hide 89438A 3.CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

a.
C179801

Connect the connector.


Hide 44348A 4.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C178170

Connect the pump hose to the vane pump with the clip.


Hide 6.INSTALL NO. 3 IDLER PULLEY (w/ Viscous Heater)

Hide 7.INSTALL NO. 1 IDLER PULLEY (w/ Viscous Heater)

Hide 16470 9.INSTALL RADIATOR RESERVOIR ASSEMBLY

Hide 17881 11.TEMPORARILY INSTALL NO. 1 AIR CLEANER HOSE

Hide 12601E 13.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53292A 14.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 53782 15.INSTALL FRONT FENDER APRON TRIM PACKING A

Hide 16.ADD POWER STEERING FLUID

Hide 17.BLEED POWER STEERING FLUID

Hide 18.INSPECT FOR POWER STEERING FLUID LEAK

Hide 19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).