Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 3UR-FE) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255440 VANE PUMP(for 3UR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 3UR-FE)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 2.CONNECT SUCTION HOSE (w/o Variable Flow Control Solenoid Valve)

a.

Connect the suction hose to the vane pump assembly with the clip.


Hide 44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE (w/ Variable Flow Control Solenoid Valve)

a.

Coat a new O-ring with power steering fluid and install the O-ring to the No. 1 oil reservoir to pump hose.


b.

Install the No. 1 oil reservoir to pump hose with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


c.

Connect the No. 1 oil reservoir to pump hose to the oil reservoir with the clip.


Hide 44410 4.CONNECT PRESSURE FEED TUBE (w/o Variable Flow Control Solenoid Valve)

a.

Install a new gasket to the pressure feed tube.


b.

Connect the pressure feed tube with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 44410 5.CONNECT PRESSURE FEED TUBE ASSEMBLY (w/ Variable Flow Control Solenoid Valve)

a.

Install a new gasket to the pressure feed tube assembly.


b.

Connect the pressure feed tube with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the 2 connectors and 2 wire harness clamps.


Hide 6.CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR (w/o Variable Flow Control Solenoid Valve)

a.

Connect the connector.


b.

Attach the wire harness clamp.


Hide 53782 11.INSTALL FRONT FENDER APRON TRIM PACKING A

Hide 13.ADD POWER STEERING FLUID

Hide 15.INSPECT FOR POWER STEERING FLUID LEAK

Hide 16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).