44310
1.INSTALL VANE PUMP ASSEMBLY
Coat a new O-ring with power steering fluid and install it to the vane pump.
Install the vane pump with the 2 nuts.
44410
2.CONNECT PRESSURE FEED TUBE ASSEMBLY
Install a new gasket to the pressure feed tube.
Install the pressure feed tube and union with the union bolt.
Make sure that the stopper of the tube touches the vane pump body as shown in the illustration before tightening the bolt.
89438A
3.CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR
Connect the 2 connectors.
44348A
4.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
Connect the pump hose to the vane pump with the clip.
16361A
5.INSTALL V-RIBBED BELT
6.INSTALL NO. 3 IDLER PULLEY (w/ Viscous Heater)
7.INSTALL NO. 1 IDLER PULLEY (w/ Viscous Heater)
8.INSTALL V-RIBBED BELT (w/ Viscous Heater)
16470
9.INSTALL RADIATOR RESERVOIR ASSEMBLY
17861
10.INSTALL INTAKE AIR CONNECTOR
17881
11.TEMPORARILY INSTALL NO. 1 AIR CLEANER HOSE
17705
12.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
12601E
13.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
53292A
14.INSTALL UPPER RADIATOR SUPPORT SEAL
53782
15.INSTALL FRONT FENDER APRON TRIM PACKING A
16.ADD POWER STEERING FLUID
17.BLEED POWER STEERING FLUID
18.INSPECT FOR POWER STEERING FLUID LEAK
19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).