Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1VD-FTV) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255446 VANE PUMP(for 1VD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1VD-FTV)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 53782 4.REMOVE FRONT FENDER APRON TRIM PACKING A

Hide 12601E 5.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 16470 9.REMOVE RADIATOR RESERVE TANK ASSEMBLY

Hide 10.REMOVE V-RIBBED BELT (w/ Viscous Heater)

Hide 11.REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)

Hide 12.REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)

Hide 14.DRAIN POWER STEERING FLUID

Hide 44348A 15.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C178170

Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the vane pump.


Hide 44410 16.REMOVE PRESSURE FEED TUBE ASSEMBLY (w/ Variable Flow Control Solenoid Valve)

a.
C253138

Disconnect the 2 connectors.


b.
C253139

Remove the union bolt, union and disconnect the pressure feed tube.


c.

Remove the gasket.


Hide 44410 17.REMOVE PRESSURE FEED TUBE ASSEMBLY (w/o Variable Flow Control Solenoid Valve)

a.
C179801

Disconnect the connector.


b.
C179802

Remove the union bolt, union and disconnect the pressure feed tube.


c.

Remove the gasket.


Hide 44310 18.REMOVE VANE PUMP ASSEMBLY (w/ Variable Flow Control Solenoid Valve)

a.
C250831

Remove the 2 nuts and vane pump.


b.

Remove the O-ring from the vane pump.


Hide 44310 19.REMOVE VANE PUMP ASSEMBLY (w/o Variable Flow Control Solenoid Valve)

a.
C178174

Remove the 2 nuts and vane pump.


b.

Remove the O-ring from the vane pump.