Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C1592/52  Actuator Neutral Position Calibration Incomplete  


DESCRIPTION

The steering control ECU first checks the actuator angle neutral position calibration flag after entering test mode. If the ECU detects that steering actuator angle neutral position calibration is incomplete twice, it will store DTC C1592/52.

DTC Code DTC Detection Condition Trouble Area
C1592/52 The steering control ECU detects that steering actuator angle neutral position calibration is incomplete twice.
·

Steering actuator

·

Steering control ECU



PROCEDURE

1.CLEAR DTC

NEXT

2.PERFORM VGRS SYSTEM CALIBRATION
2.PERFORM VGRS SYSTEM CALIBRATION

NEXT

3.CHECK DTC
3.CHECK DTC
a.

Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
C1592/52 is output after VGRS system calibration has been performed 3 times or more A
C15B2/72 is output (for LHD) B
C15B2/72 is output ( for RHD) C
DTC is not output D

NOTICE:

If DTC C1592/52 is output even though the VGRS system calibration has been performed, confirm the procedure again, and perform the VGRS system calibration 3 times or more.




A

REPLACE STEERING ACTUATOR ASSEMBLY

B

C

D

END