Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C1595/55  Lost Communication with Steering Angle Sensor Module  C15C4/68  Steering Angle Signal (Test Mode DTC)  


DESCRIPTION

Signal transmission between the VGRS ECU (steering control ECU) and steering sensor is performed via serial communication.

If a serial communication error occurs between the VGRS ECU (steering control ECU) and steering sensor, the ECU stores DTC C1595/55.

The test mode DTC C15C4/68 is only stored during test mode.

DTC No. DTC Detection Condition Trouble Area
C1595/55 With the engine switch on (IG) and a power source voltage of 10 V or more, serial communication from the steering sensor is interrupted for 3 seconds or more.
·

Steering sensor

·

VGRS ECU (steering control ECU)

·

Harness or connector


C15C4/68 The system enters test mode.
·

Steering sensor

·

VGRS ECU (steering control ECU)

·

Harness or connector



WIRING DIAGRAM

C248782E18
5.74,1.167 6.125,1.333 0.385,0.167 10 false SS1- 5.74,0.729 6.135,0.917 0.396,0.188 10 false SS1+ 1.115,1.177 1.5,1.375 0.385,0.198 10 false SS2- 1.094,0.74 1.5,0.938 0.406,0.198 10 false SS2+ 1.573,0.615 1.729,0.802 0.156,0.188 10 false 8 1.563,1.073 1.75,1.24 0.188,0.167 10 false 9 5.542,1.073 5.677,1.24 0.135,0.167 10 false 5 5.531,0.646 5.646,0.813 0.115,0.167 10 false 6 4.917,1.813 6.542,2.188 1.625,0.375 10 false VGRS ECU (Steering Control ECU) 0.74,1.781 1.896,2.188 1.156,0.406 10 false Steering Sensor 4.917,1.646 5.458,1.896 0.542,0.25 10 false E161 0.74,1.625 1.167,1.813 0.427,0.188 10 false E163

CAUTION / NOTICE / HINT

NOTICE:

When replacing the VGRS ECU (steering control ECU), perform actuator angle neutral point calibration and initialization after replacement (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK DTC
a.

Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTCs C15C1/74, C15C2/74 and U0126/56 are not output A
DTCs C15C1/74, C15C2/74 and U0126/56 are output B



A

2.CHECK HARNESS AND CONNECTOR (VGRS ECU (STEERING CONTROL ECU) - STEERING SENSOR)

B

2.CHECK HARNESS AND CONNECTOR (VGRS ECU (STEERING CONTROL ECU) - STEERING SENSOR)
a.

Turn the engine switch off.


b.

Disconnect the E161 VGRS ECU (steering control ECU) connector.


c.

Disconnect the E163 steering sensor connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E161-5 (SS1-) - E163-9 (SS2-) Always Below 1 Ω
E161-6 (SS1+) - E163-8 (SS2+) Always Below 1 Ω
E161-5 (SS1-) or E163-9 (SS2-) - Body ground Always 100 kΩ or higher
E161-6 (SS1+) or E163-8 (SS2+) - Body ground Always 100 kΩ or higher
E161-5 (SS1-) - E161-6 (SS1+) Always 1000 kΩ or higher




OK

3.CHECK STEERING SENSOR

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK STEERING SENSOR
a.
U165227E02
2.427,1.052 2.115,1.344 2.115,1.344 2.115,1.563 false 2.479,1.052 2.885,1.344 2.885,1.344 2.885,1.563 false 0.083,0.052 0.26,0.229 0.177,0.177 10 false *a 1.75,1.604 2.375,1.802 0.625,0.198 10 false 6 (SS1+) 2.573,1.604 3.156,1.802 0.583,0.198 10 false 5 (SS1-) 1.573,0.25 1.938,0.417 0.365,0.167 10 false E161

Reconnect the E161 VGRS ECU (steering control ECU) connector.


b.

Reconnect the E163 steering sensor connector.


c.

Start the engine.


d.

Measure the voltage according to the value(s) in the table below.

HINT:

With the connector connected to the VGRS ECU (steering control ECU), measure the voltage from the rear of the connector.


Standard Voltage:
Tester Connection Condition Specified Condition
E161-5 (SS1-) - E161-6 (SS1+) Steering wheel rotated slowly Pulse waveform that alternates between 0 and 5 V is output


Text in Illustration
*a Component with harness connected
(VGRS ECU [Steering Control ECU])

Result
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

REPLACE VGRS ECU (STEERING CONTROL ECU)

B

REPLACE VGRS ECU (STEERING CONTROL ECU)

C