Home › Power Source / Network › 1VD-FTV (BATTERY / CHARGING) › GENERATOR
RM2660E _57 Power Source / Network _052833 1VD-FTV BATTERY / CHARGING _0255523 GENERATOR A

1VD-FTV BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53806 3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53736G 7.REMOVE FRONT FENDER APRON SEAL FRONT RH

Hide 53738A 8.REMOVE FRONT FENDER APRON SEAL REAR RH

Hide 87120H 9.REMOVE V-RIBBED BELT (w/ Viscous Heater)

Hide 16630H 10.REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)

Hide 11.REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)

Hide 17940D 13.REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

Hide 17971 14.REMOVE NO. 1 COOL AIR INLET (w/o Intercooler)

Hide 17972 15.REMOVE NO. 2 COOL AIR INLET (w/o Intercooler)

Hide 87209 16.DISCONNECT WATER HOSE SUB-ASSEMBLY (w/ Viscous Heater)

a.
U163118

Disconnect the 2 water hoses.


Hide 17.REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 87208 23.REMOVE HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)

Hide 17885 24.REMOVE NO. 1 AIR CLEANER PIPE SUB-ASSEMBLY

Hide 17360A 25.REMOVE NO. 1 AIR TUBE ASSEMBLY

a.
A174709

Remove the bolt and No. 1 air tube.


b.

Remove the O-ring.


Hide 27020 26.REMOVE GENERATOR ASSEMBLY

a.

Disconnect the 4 connectors.


b.
A178941

Disconnect the 6 wire harness clamps.


c.

Remove the terminal cap.


d.

Remove the nut and disconnect the generator wire.


e.

Remove the bolt and disconnect the wire harness bracket from the belt tensioner.


f.
A185246

Loosen the clamp and remove the bolt.


g.
A180129

Remove the 2 bolts and No. 1 intake air connector bracket.


h.

Remove the No. 1 intake air connector pipe from the No. 1 inlet compressor elbow.


i.
A163034

Remove the 3 bolts and 2 nuts.


j.

Using an E7 "TORX" socket wrench, remove the 2 stud bolts and generator.