Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU (for RHD) › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255819 HEADLIGHT LEVELING ECU(for RHD) A

LIGHTING (EXT)  HEADLIGHT LEVELING ECU(for RHD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 89960 1.INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (for Static Headlight Auto Leveling)

a.

Install the headlight leveling ECU with the nut.


Hide 89940 2.INSTALL HEADLIGHT SWIVEL ECU ASSEMBLY (for Dynamic Headlight Auto Leveling)

a.

Install the headlight swivel ECU assembly with the nut.


Hide 3.INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (for Static Headlight Auto Leveling)

Hide 85940 4.INSTALL WINDSHIELD WIPER RELAY ASSEMBLY

Hide 55433B 5.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 55476A 7.INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55607 10.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55403C 13.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55449C 14.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).