Use the same procedures for the LHD vehicle and RHD vehicle.
The procedures listed below are for the LHD vehicle.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55510F
3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
55670
4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
86120
6.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
w/o Stereo Component Amplifier:
(See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/o Stereo Component Amplifier)>REMOVAL)
w/o Multi-dsplay:
(See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/o Multi-display)>REMOVAL)
55412C
7.REMOVE NO. 1 CENTER INSTRUMENT CLUSTER FINISH PANEL
55449C
8.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
9.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55448A
10.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
55402C
11.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
55406B
12.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55900
13.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Pull the radio receiver to detach the 5 claws on the backside of the radio receiver.
Disconnect the connectors and remove the radio receiver.