| *A | w/ Electronic-Kinetic Dynamic Suspension System | *B | w/ Height Control Sensor |
| *1 | REAR STABILIZER CONTROL ARM ASSEMBLY | *2 | LOWER BALL JOINT DUST COVER PROTECTOR |
| ● | Non-reusable part | - | - |
| *A | w/o Electronic-Kinetic Dynamic Suspension System | *B | w/ Height Control Sensor |
| *1 | REAR STABILIZER BAR SUB-ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear coil spring removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
42306 4.DISCONNECT REAR AXLE BREATHER HOSE SUB-ASSEMBLY
89407B 5.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ Height Control Sensor)
48802 7.DISCONNECT STABILIZER LINK SUB-ASSEMBLY (w/ Electronic-Kinetic Dynamic Suspension System)
48805 8.DISCONNECT REAR STABILIZER BAR SUB-ASSEMBLY (w/ Electronic-Kinetic Dynamic Suspension System)
48840A 9.DISCONNECT REAR STABILIZER LINK ASSEMBLY LH (w/o Electronic-Kinetic Dynamic Suspension System)
48830D 10.DISCONNECT REAR STABILIZER LINK ASSEMBLY RH (w/o Electronic-Kinetic Dynamic Suspension System)
Use the same procedure described for the LH side.
48740 11.DISCONNECT REAR LATERAL CONTROL ROD ASSEMBLY
12.DISCONNECT REAR FLEXIBLE HOSE
Remove the 2 clips.
Disconnect the 2 rear flexible hoses from the vehicle body.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
48540 13.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH
48530 14.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY RH
48231B 15.REMOVE REAR COIL SPRING LH
While lowering the axle housing, remove the coil spring LH.
Be careful not to snap the brake line.
48302 16.REMOVE HOLLOW SPRING SUB-ASSEMBLY