| *1 | NO. 3 TURBO WATER PIPE SUB-ASSEMBLY | *2 | VENTILATION HOSE |
| *3 | NO. 3 FUEL VAPOR FEED HOSE | *4 | FUEL HOSE BRACKET |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1. DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
22030 4.REMOVE THROTTLE WITH THROTTLE POSITION SENSOR BODY ASSEMBLY
89421Q 5.REMOVE NO. 3 TURBO PRESSURE SENSOR
17190 6.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
87209 7.DISCONNECT WATER HOSE SUB-ASSEMBLY
1629A 8.DISCONNECT NO. 14 WATER BY-PASS HOSE
16289 9.REMOVE NO. 5 WATER BY-PASS PIPE
1628A 12.DISCONNECT NO. 6 WATER BY-PASS PIPE
23891 14.REMOVE FUEL DELIVERY SPACER
23291 15.REMOVE INJECTOR VIBRATION INSULATOR
17111 16.REMOVE INTAKE MANIFOLD