The speed sensor detects the wheel speed and sends the appropriate signals to the brake actuator assembly (skid control ECU). These signals are used for brake control.
The speed sensor detects changes in the magnetic field emitted from the speed sensor rotor and generates a vehicle speed pulse. The brake actuator assembly (skid control ECU) detects the speed of each wheel using this vehicle speed pulse.
When the connectors between the speed sensor and brake actuator assembly (skid control ECU) are connected, the following waveform is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1271 | Low Output Signal of Front Speed Sensor RH (Test Mode DTC) | Stored only during test mode. |
·
Front speed sensor RH
·
Front axle hub sub-assembly RH (Front speed sensor rotor RH)
·
Front speed sensor RH installation |
| C1272 | Low Output Signal of Front Speed Sensor LH (Test Mode DTC) | Stored only during test mode. |
·
Front speed sensor LH
·
Front axle hub sub-assembly LH (Front speed sensor rotor LH)
·
Front speed sensor LH installation |
| C1401 | Front Speed Sensor RH Malfunction | One of the following conditions is met:
1.
At a vehicle speed of 10 km/h (6 mph) or more, the output voltage from one of the speed sensors is less than that from the other sensors for 15 seconds or more.
2.
At a vehicle speed of less than 10 km/h (6 mph), the output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more.
3.
At a vehicle speed of 10 km/h (6 mph) or more, the outputs from both front speed sensors are 0 km/h (0 mph) for 30 seconds or more. |
·
Front speed sensor RH
·
Front axle hub sub-assembly RH (Front speed sensor rotor RH)
·
Front speed sensor RH installation |
| C1402 | Front Speed Sensor LH Malfunction | One of the following conditions is met:
1.
At a vehicle speed of 10 km/h (6 mph) or more, the output voltage from one of the speed sensors is less than that from the other sensors for 15 seconds or more.
2.
At a vehicle speed of less than 10 km/h (6 mph), the output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more.
3.
At a vehicle speed of 10 km/h (6 mph) or more, the outputs from both front speed sensors are 0 km/h (0 mph) for 30 seconds or more. |
·
Front speed sensor LH
·
Front axle hub sub-assembly LH (Front speed sensor rotor LH)
·
Front speed sensor LH installation |
DTCs C1401 and C1271 are for the front speed sensor RH.
DTCs C1402 and C1272 are for the front speed sensor LH.
Check the speed sensor signal after cleaning or replacement.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE
Turn the ignition switch off.
| *1 | Front Speed Sensor |
| *a | No Clearance |
| *b | OK |
| *c | NG |
Check the speed sensor installation.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR(w/ ABS)>INSTALLATION
There is no clearance between the sensor and the front steering knuckle.
The installation bolt is tightened properly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front speed sensor.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR(w/ ABS)>REMOVAL
Check the speed sensor tip.
No scratches, oil, or foreign matter on the sensor tip.
If no damage to the speed sensor tip is found during this inspection, do not replace the speed sensor.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front axle hub and front disc.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>REMOVAL
Check the speed sensor rotor.
No scratches, oil, or foreign matter on the rotors.
The front speed sensor rotor is incorporated into the front axle hub sub-assembly.
If the front speed sensor rotor needs to be replaced, replace it together with the front axle hub sub-assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Install the front axle hub and front disc.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>INSTALLATION
Install the front speed sensor.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR(w/ ABS)>INSTALLATION
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Wheel Speed | Front speed sensor RH reading | Min.: 0 km/h (0 mph) Max.: 326 km/h (202 mph) |
Actual wheel speed | No large fluctuations when driving at a constant speed. |
| FL Wheel Speed | Front speed sensor LH reading | Min.: 0 km/h (0 mph) Max.: 326 km/h (202 mph) |
Actual wheel speed | No large fluctuations when driving at a constant speed. |
| Tester Display |
|---|
| FR Wheel Speed |
| FL Wheel Speed |
Check that there is no difference between the speed value output from the speed sensor displayed on the GTS and the speed value displayed on the speedometer when driving the vehicle.
Factors that affect the indicated vehicle speed include tire size, tire inflation and tire wear. The speed indicated on the speedometer has an allowable margin of error.
This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to the reference chart.
The speed value output from the speed sensor displayed on the GTS is the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Replace the front speed sensor.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR(w/ ABS)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTC.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
DTC is output