Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2019.09–2022.09
RM25T0E _V1 General _030611 INTRODUCTION _0140189 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
ECM Register VIN DTC P0630 is output (Click here)(for 1GR-FE)
(Click here)(for 1VD-FTV)
(Click here)(for 1VD-FTV, w/ DPF)
(Click here)(for 1VD-FTV, w/o EGR System)
for 1VD-FTV:

Supply pump initialization


Engine startability (Click here)
for 1VD-FTV, w/ DPF:
·

Learning values save

·

Learning values write

·

Supply pump initialization


Engine starting (Click here)(for Initialization)
(Click here)(for Registration)
for 1VD-FTV, w/o EGR System:

Supply pump initialization


Engine startability (Click here)
for 1VD-FTV:

Fuel injector(s)


Injector compensation code(s) registration DTC is output. (Click here)
for 1VD-FTV, w/o EGR System:

Fuel injector(s)


Injector compensation code(s) registration DTC is output. (Click here)
for 1VD-FTV:

Fuel supply pump assembly


Supply pump initialization Engine startability (Click here)
for 1VD-FTV, w/ DPF:

Fuel supply pump assembly


Supply pump initialization Engine startability (Click here)
for 1VD-FTV, w/o EGR System:

Fuel supply pump assembly


Supply pump initialization Engine startability (Click here)
Engine assembly
for 1VD-FTV, w/ DPF:
·

Clear Crank Time Compensation Data

·

Input Injector Compensation Code

·

Pilot Quantity Learning


Engine starting (Click here)(for Initialization)
(Click here)(for Registration)
for 1VD-FTV, w/ DPF:

Crankshaft position sensor plate


Clear Crank Time Compensation Data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data (Click here)
for 1VD-FTV, w/ DPF:

Air fuel ratio sensor


Clear A/F Sensor Compensation data EGR volume is affected (Click here)
for 1VD-FTV, w/ DPF:

Front exhaust pipe assembly (DPF catalytic converter)


·

Clear DPF Thermal Deterioration Data

·

Learning Values Write


Even if catalytic converter is replaced with new one, catalyst record of DPF thermal deterioration stored in ECM is same as before replacement (Click here)(for Initialization)
(Click here)(for Registration)
for 1VD-FTV, w/ DPF:

Injector assembly


·

Input Injector Compensation Code

·

Pilot Quantity Learning


DTC P062F is output (Click here)
for 1VD-FTV, w/ DPF:

Electric EGR control valve assembly


Perform initialization - (Click here)
for 1VD-FTV, w/ DPF:

Front exhaust pipe assembly (DPF catalytic converter)


Clear DPF Thermal Deterioration Data - (Click here)
for 1VD-FTV, w/ DPF:

Diesel throttle body assembly


Perform initialization - (Click here)
·

Tire pressure warning ECU and receiver

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, tire pressure warning light blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


(Click here)(for Initialization)
(Click here)(for Registration)
Skid control ECU (Brake actuator assembly)
w/o VSC:

Perform registration of rear differential lock identification information


·

DTCs are output

·

ABS warning light illumination


(Click here)
w/ VSC:

Yaw rate and acceleration sensor zero point calibration and store system information


·

DTCs are output

·

ABS warning light illumination

·

Slip indicator light illumination

·

VSC disable or malfunctioning


(Click here)
·

Yaw rate and acceleration sensor (airbag sensor assembly)

·

Wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


·

Transponder key ECU assembly

·

ECM

·

Key


Registration Engine starting Refer to the Service Bulletin for the registration procedure.
·

Door control transmitter

·

Door control with receiver ECU assembly


Register recognition code Wireless door lock operation (Click here)
for 1HZ:

Timing belt


Information mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


(Click here)