| ● | Non-reusable part | ★ | Precoated part |
| *1 | FC AIR BY-PASS VALVE PIPE ASSEMBLY | *2 | WIRE HARNESS CLAMP BRACKET |
| *3 | STUD BOLT | - | - |
| ● | Non-reusable part | - | - |
1A906
3.REMOVE FC STACK COVER SUB-ASSEMBLY
51441N
4.REMOVE FRONT COMPARTMENT UNDER COVER
51219
5.REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR
51420A
6.REMOVE FRONT COMPARTMENT UNDER COVER ASSEMBLY
58404B
7.REMOVE REAR NO. 4 FLOOR BOARD SUB-ASSEMBLY
8.DRAIN COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed))
11.DISCONNECT FC INTERCOOLER HOSE
| *1 | No. 1 FC Intercooler Hose | *2 | No. 2 FC Intercooler Hose |
| *3 | No. 3 Radiator Hose Bracket | - | - |
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the No. 1 FC intercooler hose, No. 2 FC intercooler hose and intercooler with sensor assembly with plastic bags.
17B21
12.REMOVE FC STACK AIR INLET HOSE
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the FC stack air inlet hose, intercooler with sensor assembly and FC stack air inlet pipe assembly with plastic bags.
17900
13.REMOVE INTERCOOLER WITH SENSOR ASSEMBLY
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the air hose and FC air compressor with motor assembly with plastic bags.
17341Y
14.REMOVE AIR HOSE
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the air hose and intercooler with sensor assembly with plastic bags.
89421S
15.REMOVE TURBO PRESSURE SENSOR