1.INSPECT AND ADJUST BRAKE PEDAL HEIGHT
Inspect and adjust the brake pedal height with the floor carpet folded back.
Perform the inspection from the service hole in the dash panel insulator.
Check the brake pedal height.
Measure the shortest distance between the brake pedal pad surface and front floor footrest as shown in the illustration.
| *1 | Brake Pedal Pad | - | - |
| *a | Brake Pedal Height | *b | Measuring Plane of Front Floor Footrest |
| *c | 41 mm (1.61 in.) | - | - |
|
Service Hole | - | - |
184.9 to 194.9 mm (7.28 to 7.67 in.)
If the brake pedal height is not as specified, inspect and adjust the push rod length according to the procedure below.
Adjust the push rod length.
Remove the instrument panel safety pad sub-assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
Remove the steering column assembly.
for Manual Tilt and Manual Telescopic Steering Column:
for Power Tilt and Power Telescopic Steering Column:
| *1 | Lock Nut |
| *2 | Stop Light Switch Assembly |
| *a | Brake Pedal Height |
Remove the stop light switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL
Loosen the lock nut and adjust the brake pedal height by turning the push rod to achieve the correct height.
184.9 to 194.9 mm (7.28 to 7.67 in.)
Tighten the lock nut.
Install the stop light switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION
Install the steering column assembly.
for Manual Tilt and Manual Telescopic Steering Column:
for Power Tilt and Power Telescopic Steering Column:
Install the instrument panel safety pad sub-assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION
89510D
2.ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY
3.PERFORM CALIBRATION
4.INSPECT BRAKE PEDAL FREE PLAY
| *a | Brake Pedal Free Play |
Depress the brake pedal until a slight resistance is felt. Measure the distance as shown in the illustration.
1.0 to 6.0 mm (0.0394 to 0.236 in.)
If the brake pedal free play is not as specified, check the stop light switch clearance.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION
If the brake pedal free play is as specified, proceed to the Inspect Brake Pedal Reserve Distance procedure.
5.INSPECT BRAKE PEDAL RESERVE DISTANCE
Inspect and adjust the brake pedal height with the floor carpet folded back.
Perform the inspection from the service hole in the dash panel insulator.
With the ignition switch on (READY), depress the brake pedal and measure the brake pedal reserve distance as shown in the illustration.
| *1 | Brake Pedal Pad | - | - |
| *a | Brake Pedal Height | *b | Measuring Plane of Front Floor Footrest |
| *c | 41 mm (1.61 in.) | - | - |
|
Service Hole | - | - |
102 mm (4.02 in.) or more