| When the vehicle speed increases in the automatic display mode, the panoramic view and wide front view screen or side clearance view screen remains displayed, without switching to the navigation screen.
|
Replace parking assist ECU
|
|
| The screen display timer function does not operate if the manual display mode is selected.
|
Refer to "Panoramic View Screen Description" in system description
|
|
| Parking assist ECU
|
|
| The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead.
|
Check the steering wheel installation angle
|
|
| Adjust steering angle
|
|
| Camera view adjustment (calibration)
|
|
| Parking assist ECU
|
|
| Estimated course lines stop moving before the steering wheel is turned fully left.
|
Steering angle setting (calibrate stored maximum steering angle)
|
|
| "!" is displayed and estimated course lines are not displayed.
|
Check if the luggage compartment door is not open
|
-
|
| Parking assist ECU
|
|
| Radio receiver assembly
|
|
| Estimated course lines are not displayed.
|
Check the panoramic view monitor screen display mode settings (Check if the estimated course lines display is set to off)
|
|
| Parking assist ECU
|
|
| "!" is displayed.
|
Store the steering angle sensor steering neutral point
|
|
| Diagnostic mode - Signal connection check (CAN check)
|
|
| "!" remains displayed after the steering neutral point is stored.
|
Adjust steering angle
|
|
| Spiral with sensor cable sub-assembly
|
|
| Parking assist ECU
|
|
| "!" is displayed and all the buttons on the screen are grayed out.
|
Camera view adjustment (calibration)
|
|
| Adjust steering angle
|
|
| Navigation System
|
|
| "!" is displayed and all the buttons on the screen are grayed out even after television camera controller initialization has been completed.
|
Parking assist ECU
|
|
| Navigation System
|
|
| Guide lines and buttons are not displayed on the panoramic view and rear view screen display screen.
|
Check if the luggage compartment door is not open
|
-
|
| Check if the luggage light turns on and off normally (If not, refer to Lighting System (INT) - Problem Symptoms Table)
|
|
| Parking assist ECU
|
|
| "CHK" is displayed for an item on the Vehicle Signal Check screen.
|
Diagnostic mode - Signal connection check
|
|
| Blind spots in image.
|
Ensure no door is opened
|
-
|
| Camera view adjustment (calibration)
|
|
| Camera boundary lines are poorly connected.
|
Camera view adjustment (calibration)
|
|
| Estimated course lines are displaced.
|
Camera view adjustment (calibration)
|
|
| Adjust steering angle
|
|
| All buttons on the panoramic view monitor are continuously grayed out
|
Navigation System
|
|
| When adjusting the camera optical axis, "You can not calibrate the camera when the door is open. Please close the door." is displayed even after the luggage compartment door has been closed
|
Check if the luggage light turns on and off normally (If not, refer to Lighting System (INT) - Problem Symptoms Table)
|
|
| Parking assist ECU
|
|
| Parking assist light does not illuminate at low light level
|
Proceed to "Infrared light does not Turn ON at Low Illumination Time"
|
|