| ● | Non-reusable part | ★ | Precoated part |
| *1 | NO. 7 FC RADIATOR HOSE | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the FC cooling ion water exchanger assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
2. CAUTIONS FOR COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed))
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
51441N
4.REMOVE FRONT COMPARTMENT UNDER COVER
51219
5.REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR
51420A
6.REMOVE FRONT COMPARTMENT UNDER COVER ASSEMBLY
1A906
7.REMOVE FC STACK COVER SUB-ASSEMBLY
53292A
8.REMOVE UPPER RADIATOR SUPPORT SEAL
53291B
9.REMOVE RADIATOR COVER PLATE
53295
10.REMOVE LOWER RADIATOR AIR DEFLECTOR
11.DRAIN COOLANT (TOYOTA GENUINE FC STACK COOLANT (Pre-mixed))
16579A
12.DISCONNECT NO. 9 FC RADIATOR HOSE
Slide the hose clip and disconnect the No. 9 FC radiator hose from the FC cooling ion water exchanger assembly.
To prevent contamination by foreign matter, cover the connecting portions of the No. 9 FC radiator hose and FC cooling ion water exchanger assembly with plastic bags.
1657D
13.DISCONNECT NO. 13 FC RADIATOR HOSE
Slide the hose clip and disconnect the No. 13 FC radiator hose from the FC cooling ion water exchanger assembly.
To prevent contamination by foreign matter, cover the connecting portions of the No. 13 FC radiator hose and FC cooling ion water exchanger assembly with plastic bags.
16567D
14.DISCONNECT RADIATOR TO RESERVE TANK HOSE
G91D4
15.DISCONNECT NO. 4 FC INVERTER COOLING PIPE
16A45
16.REMOVE FC COOLING WATER ION EXCHANGER BRACKET
16A40
17.REMOVE FC COOLING WATER ION EXCHANGER ASSEMBLY
Remove the 3 bolts.
Detach the clamp and remove the FC cooling ion water exchanger assembly.