| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | BATTERY ECU ASSEMBLY | 89890A | ( )
|
- | - |
| 2 | BATTERY VOLTAGE SENSOR (for Upper Side) | 89892A | ( )
|
- | - |
| *1 | NO. 1 EV BATTERY PROTECTOR (for Upper Side) | *2 | WIRE HARNESS (NO. 2 HV SUPPLY STACK SUB-ASSEMBLY) CELL VOLTAGE DETECTION CIRCUIT |
| *3 | NO. 1 EV BATTERY PACK WIRE | *4 | NO. 2 EV BATTERY PACK WIRE |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | EV SUPPLY BATTERY ASSEMBLY | G9510B | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | FC CONVERTER POWER OUTLET CABLE (INVERTER WITH CONVERTER ASSEMBLY) | G9200A | ( )
|
- | - |
| 9 | FC STACK COVER SUB-ASSEMBLY | 1A906 | - | - | - |
| 10 | UPPER RADIATOR SUPPORT SEAL | 53292A | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | SERVICE PLUG GRIP | G3834 | - | - | - |
| 12 | CURRENT SENSOR OFFSET LEARNING | - | - | - | ( )
|
89890A
1.INSTALL BATTERY ECU ASSEMBLY
|
|
Install the battery ECU assembly with the 2 nuts.
Do not drop the battery ECU assembly, strike it with tools or subject it to impact.
If the battery ECU assembly is subjected to an impact, replace it with a new one.
Connect the 2 connectors.
Make sure that the connector is connected securely.
G9510B
7.INSTALL EV SUPPLY BATTERY ASSEMBLY
1A906
9.INSTALL FC STACK COVER SUB-ASSEMBLY
53292A
10.INSTALL UPPER RADIATOR SUPPORT SEAL
G3834
11.INSTALL SERVICE PLUG GRIP