Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM T

FC CONTROL  FC CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


FC Control System
Symptom Suspected Area Link
"Active Purge Mode ON" is not displayed on the multi-information display, despite pressing the FC water release switch while the ignition switch is ON FC water release switch circuit Click here
Combination meter assembly Click here
FC water release switch Click here
Hesitation and/or poor acceleration Vehicle Control History
("FC Output Limit" is stored in the memory)
Click here
Ignition switch does not turn ON (READY).*2 Auxiliary battery (Low voltage) Click here
Fuel lid (Open lid) -
Hydrogen (fuel) ran out Vehicle Control History
("Hydrogen Empty Low Level" is stored in the memory)
Click here
Hydrogen filling stopped Vehicle Control History
("Hydrogen Filling Abort" is stored in the memory)
Click here
Hydrogen filling continues long If the ambient temperature is high when filling hydrogen, extra time is required to complete it. Also, filling time may vary depending on the hydrogen stations. -
Filling was completed, but the tank is not full The vehicle was refueled at a hydrogen station without communication filling system. -
Hydrogen station factors:
·

Filling pressure decreased

·

Interlocks were actuated


-
Vehicle Control History
("Hydrogen Filling Abort" is stored in the memory)
Click here
Infrared transmitter circuit*1 Click here
The fuel lid is actually closed, but the multi-information display shows "Open Filler Door Detected Close Hydrogen Filler Door Restart Vehicle" and so READY ON is not possible. Fuel lid interlock circuit Click here
Combination meter assembly Click here
After the ignition switch is turned to ON or ON (READY), "Open Filler Door Detected Stop in a Safe Place Close Hydrogen Filler Door" is displayed on the multi-information display despite the fact that the fuel lid is actually closed. Fuel lid interlock circuit Click here
Combination meter assembly Click here
After the ignition switch is turned to ON or ON (READY), "FCV System Shutdown Due to Freezing Stop in a Safe Place See Owner's Manual" is displayed on the multi-information display despite the fact that the fuel lid is actually closed. Vehicle Control History
("FC System Start Up at Very Low Temperature" is stored in the memory)
Click here
When starting at below the freezing point, it takes a long time for the READY light to change from blinking to on after turning the ignition switch to ON (READY) (pressing the power switch while depressing the brake pedal)

*1: It can be assumed that the tank was not refilled full due to infrared signal transmission errors from the vehicle to a hydrogen station. To confirm DTC P1E1996 (Infrared Transmitter Circuit), turn the ignition switch to ON with the fuel lid open and wait for 10 seconds. (DTC will not be stored when ignition switch is off.)

*2: Refer to the problem symptoms table for the hybrid control system as well.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE