1. PRECAUTION
G9200
2.REMOVE INVERTER WITH CONVERTER ASSEMBLY
G9110
3.REMOVE INVERTER BRACKET ASSEMBLY
51201
4.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
5.REMOVE REAR SEAT CUSHION ASSEMBLY
71033
6.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G92F1
7.REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT
G9230
8.REMOVE BATTERY COOLING BLOWER ASSEMBLY
G92N1A
9.REMOVE NO. 1 HYBRID VEHICLE BATTERY COVER PANEL LH
10.DISCONNECT CABLE FROM POSITIVE AUXILIARY BATTERY TERMINAL
Remove the connector cover.
Remove the nut and disconnect the positive auxiliary battery terminal.
82164
11.REMOVE FRAME WIRE
Wear insulated gloves.
Insulate the disconnected terminals with insulating tape.
Disconnect the connector.
Disconnect the 2 connectors.
| *1 | Shielded Wire Ground |
Disconnect the shielded wire ground.
Disconnect the 6 clamps.
Disengage the claw and disconnect the frame wire from the engine room junction block assembly.
Disconnect the clamp.
Disconnect the clamp.
Disconnect the clamp.
Disconnect the clamp.
Remove the 3 nuts.
Disconnect the 4 clamps and remove the frame wire.
The clamps are non-reusable parts.