1.INSTALL ENGINE STAND
25612
2.REMOVE NO. 2 EGR PIPE
25680
3.REMOVE EGR VALVE WITH COOLER ASSEMBLY
19500D
4.REMOVE IGNITION COIL ASSEMBLY
82121
5.SEPARATE ENGINE WIRE (for LHD)
82121
6.SEPARATE ENGINE WIRE (for RHD)
11201
7.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
15100Q
8.REMOVE CRANKSHAFT POSITION SENSOR
13407
9.REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY
15301
10.REMOVE ENGINE OIL LEVEL DIPSTICK
11452
11.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the bolt and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
12315A
12.REMOVE ENGINE MOUNTING BRACKET RH
Remove the 4 bolts and engine mounting bracket RH.
13.REMOVE SCREW PLUG
Using a 8 mm hexagon socket wrench, remove the screw plug.
15100
14.REMOVE TIMING CHAIN COVER
Remove the 18 bolts, nut and 2 wire harness clamp brackets.
Remove the timing chain cover by prying between the timing chain cover and oil pan, cylinder head or cylinder block with a screwdriver.
| *1 | Protective Tape |
Be careful not to damage the contact surfaces of the timing chain cover, oil pan, cylinder block, and cylinder head.
Tape the screwdriver tip before use.
Remove the 2 O-rings from the cylinder block and oil pan.
15100C
15.REMOVE OIL PUMP SEAL
Using a screwdriver and wooden block, remove the oil pump seal.
| *1 | Protective Tape |
| *2 | Wooden Block |
Do not damage the surface of the oil seal press fit hole.
Tape the screwdriver tip before use.