When removing the cooler expansion valve by itself, be sure to install a new cooler expansion valve and new bolt for suction pipe sub-assembly.
1.RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM
2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55722C
3.REMOVE INNER COWL TOP TO COWL BRACE (for LHD)
55722C
4.REMOVE INNER COWL TOP TO COWL BRACE (for RHD)
55735B
5.REMOVE FRONT AIR SHUTTER SEAL (for LHD)
55735B
6.REMOVE FRONT AIR SHUTTER SEAL (for RHD)
55815E
7.REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)
55815E
8.REMOVE FRONT NO. 1 VENTILATOR SEAL (for RHD)
55701J
9.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
10.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
88707
11.DISCONNECT SUCTION PIPE SUB-ASSEMBLY
88706
12.DISCONNECT LIQUID PIPE SUB-ASSEMBLY
88515
13.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.
Temporarily install the bolt for the suction pipe sub-assembly halfway to the cooler expansion valve.
| *a | Bolt for Suction Pipe Sub-assembly |
Hold the bolt and pull it to remove the cooler expansion valve as shown in the illustration.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
| *1 | No. 1 Cooler Evaporator Sub-assembly |