Home › General › MAINTENANCE › ENGINE › from 2017.06
RM2170E _V1 General _057002 MAINTENANCE _0277905 ENGINE N

MAINTENANCE  ENGINE  GENERAL MAINTENANCE  


CAUTION / NOTICE / HINT

HINT:

Perform these procedures after the engine has cooled down.


PROCEDURE

Hide 1.INSPECT VALVE CLEARANCE

Hide 2.REPLACE ENGINE OIL AND OIL FILTER

a.

Replace the engine oil and oil filter (See page Engine / Hybrid System>1NZ-FXE (LUBRICATION)>OIL AND OIL FILTER>REPLACEMENT).


Hide 3.REPLACE ENGINE COOLANT

Hide 4.INSPECT SPARK PLUGS

Hide 28800 5.INSPECT AUXILIARY BATTERY

Hide 17801 6.INSPECT AIR CLEANER FILTER ELEMENT

a.

Remove the air filter.


b.
A156094

Check that the air cleaner is not excessively dirty.

If the air cleaner is excessively dirty, replace the air cleaner filter element.


c.

If cleaning the air cleaner filter element, blow compressed air as shown in the illustration to clean it.


d.

Reinstall the air filter.


e.

When an excessive amount of dirt is present, replace the air filter.


Hide 7.INSPECT EXHAUST PIPES AND MOUNTINGS

a.

Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.


Hide 77316 8.INSPECT FUEL TANK CAP GASKET

Hide 9.INSPECT FUEL LINES, CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BANDS

a.

Visually check the fuel lines and hoses for cracks, leaks, loose connections, or deformation.


b.

Check for tank band looseness or deformation.


Hide 77740 10.INSPECT CHARCOAL CANISTER