Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › RADIATOR › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061911 2ZR-FXE COOLING _0301629 RADIATOR A

2ZR-FXE COOLING  RADIATOR  INSTALLATION  


PROCEDURE

Hide 16400 1.INSTALL RADIATOR ASSEMBLY

a.

Install the radiator assembly with the 2 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


b.

Install the 2 lower radiator supports.


c.

Install the radiator assembly with the fan shroud.

NOTICE:

Do not apply any excessive force to the radiator assembly (for inverter coolant), cooler condenser assembly or pipe when installing the radiator assembly.



Hide 16712 2.INSTALL NO. 2 FAN SHROUD

a.

Install the No. 2 fan shroud with the 2 bolts and 2 claws.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


b.

Connect the No. 5 inverter cooling hose and 4 clamps to the fan shroud.


c.

Connect the No. 3 water by-pass hose and 4 clamps to the No. 2 fan shroud.


d.

Connect the No. 3 water by-pass hose to the radiator assembly.


e.

Connect the No. 1 water by-pass hose to the radiator assembly.


Hide 53208A 6.INSTALL HOOD LOCK SUPPORT SUB-ASSEMBLY

a.

Install the hood lock support sub-assembly with the 4 bolts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


b.

Install the 2 radiator support cushions to the radiator support RH and radiator support LH.


c.

Install the radiator support RH and radiator support LH with the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


d.

Connect the 2 connectors.


e.

Connect the 2 clamps and 2 connectors.


f.

w/o Engine hood courtesy switch:

i.

Connect the hood lock control cable wire and clamp.



g.

w/ Engine hood courtesy switch:

i.

Connect the engine hood courtesy switch connector and clamp.


ii.

Connect the hood lock control cable wire and clamp.



h.

Connect the clamp to the radiator support RH.


Hide 88215 8.INSTALL NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET (w/ Dynamic Radar Cruise Control System)

Hide 88211B 9.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

Hide 10.INSTALL FRONT BUMPER ASSEMBLY

Hide 16572D 11.CONNECT NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose to the radiator assembly.


Hide 16571C 12.CONNECT NO. 1 RADIATOR HOSE

a.

Connect the No. 1 radiator hose to the radiator assembly.


Hide 13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 51441 16.INSTALL NO. 1 ENGINE UNDER COVER

Hide 53289A 22.INSTALL RADIATOR SUPPORT OPENING COVER