Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
73370
1.INSPECT REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY
73370
2.INSTALL REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY LH (for LH Side)
|
Bolt (A) |
|
Bolt (B) |
w/o Pretensioner:
Engage the 3 guides and temporarily install the rear 3 point type seat outer belt assembly LH with the 3 bolts.
Uniformly tighten the 3 bolts in the order shown in the illustration to install rear 3 point type seat outer belt assembly LH.
Check that the ELR locks.
This check should be performed with the rear 3 point type seat outer belt assembly LH installed to the vehicle.
With the rear 3 point type seat outer belt assembly LH installed to the vehicle, check that the belt locks when it is pulled out quickly.
w/ Pretensioner:
|
Bolt (A) |
|
Bolt (B) |
Engage the 3 guides and temporarily install the rear 3 point type seat outer belt assembly LH with the 3 bolts.
Uniformly tighten the 3 bolts in the order shown in the illustration to install rear 3 point type seat outer belt assembly LH.
| *a | Locking Button |
| *b | Lock |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Check that the ELR locks.
This check should be performed with the rear 3 point type seat outer belt assembly LH installed to the vehicle.
With the rear 3 point type seat outer belt assembly LH installed to the vehicle, check that the belt locks when it is pulled out quickly.
| *a | Protruding Part |
Install the floor anchor of the rear 3 point type seat outer belt assembly LH with the bolt.
Do not allow the anchor part of the rear 3 point type seat outer belt assembly LH to overlap the protruding parts of the floor panel.
73360
3.INSTALL REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY RH (for RH Side)
w/o Pretensioner:
|
Bolt (A) |
|
Bolt (B) |
Engage the 3 guides and temporarily install the rear 3 point type seat outer belt assembly RH with the 3 bolts.
Uniformly tighten the 3 bolts in the order shown in the illustration to install rear 3 point type seat outer belt assembly RH.
Check that the ELR locks.
This check should be performed with the rear 3 point type seat outer belt assembly RH installed to the vehicle.
With the rear 3 point type seat outer belt assembly RH installed to the vehicle, check that the belt locks when it is pulled out quickly.
w/ Pretensioner:
| *a | Locking Button |
| *b | Lock |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Engage the clamp.
|
Bolt (A) |
|
Bolt (B) |
Engage the 3 guides and temporarily install the rear 3 point type seat outer belt assembly RH with the 3 bolts.
Uniformly tighten the 3 bolts in the order shown in the illustration to install rear 3 point type seat outer belt assembly RH.
Check that the ELR locks.
This check should be performed with the rear 3 point type seat outer belt assembly RH installed to the vehicle.
With the rear 3 point type seat outer belt assembly RH installed to the vehicle, check that the belt locks when it is pulled out quickly.
| *a | Protruding Part |
Install the floor anchor of the rear 3 point type seat outer belt assembly RH with the bolt.
Do not allow the anchor part of the rear 3 point type seat outer belt assembly RH to overlap the protruding parts of the floor panel.
62480A
4.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY
64740C
5.INSTALL DECK TRIM SIDE PANEL ASSEMBLY
81330
6.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)
64937A
7.INSTALL NO. 1 TONNEAU COVER HOLDER CAP
64938
8.INSTALL TONNEAU COVER HOOK A
58460D
9.INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Side)
62552F
10.INSTALL REAR SEAT SIDE GARNISH
71304C
11.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY
76974F
12.INSTALL REAR UNDER SIDE COVER
72693
13.INSTALL REAR SEAT CUSHION LOCK HOOK
14.INSTALL REAR SEAT CUSHION ASSEMBLY
15.INSTALL REAR SEATBACK ASSEMBLY LH (for LH Side)
16.INSTALL REAR SEATBACK ASSEMBLY RH (for RH Side)
73350C
17.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
71960B
18.INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)
71940A
19.INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side)
71940A
20.INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side)
62332A
21.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
67918A
22.INSTALL REAR DOOR SCUFF PLATE
64716D
23.INSTALL REAR DECK TRIM COVER
58460D
24.INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)
64718D
25.INSTALL DECK TRIM SERVICE HOLE COVER
64995
26.INSTALL DECK FLOOR BOX RH (w/o Spare Tire)
for RH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
64997
27.INSTALL DECK FLOOR BOX LH (w/o Spare Tire)
64995
28.INSTALL DECK FLOOR BOX RH (w/ Compact Spare Tire)
for RH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
64997
29.INSTALL DECK FLOOR BOX LH (w/ Compact Spare Tire)
for LH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
64993
30.INSTALL REAR DECK FLOOR BOX (w/ Compact Spare Tire)
64997
31.INSTALL DECK FLOOR BOX LH (w/ Full Size Spare Tire)
for LH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
64995
32.INSTALL DECK FLOOR BOX RH (w/ Full Size Spare Tire)
58432D
33.INSTALL DECK BOARD RETAINER
58415E
34.INSTALL REAR NO. 1 FLOOR BOARD
64910J
35.INSTALL TONNEAU COVER ASSEMBLY
36.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
37. PERFORM DIAGNOSTIC SYSTEM CHECK
38.INSPECT SRS WARNING LIGHT