PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| No functions of A/C panel operate |
1. LIN communication line |
- |
| 2. Air conditioning control assembly |
Click here
|
|
| 3. Air conditioning amplifier |
Click here
|
|
| No functions of A/C system operate |
1. ECU-IG2 fuse |
- |
| 2. Air conditioning control assembly |
Click here
|
|
| 3. Air conditioning amplifier |
Click here
|
|
| 4. Wire harness or connector |
- |
|
| Airflow Control: No blower control (Blower motor does not operate) |
1. HTR fuse |
- |
| 2. Blower motor circuit |
Click here
|
|
| 3. Air conditioning amplifier |
Click here
|
|
| 4. Air conditioning control assembly |
Click here
|
|
| 5. Wire harness or connector |
Click here
|
|
| Airflow Control: No blower control (Blower motor does not change speed) |
1. Blower motor circuit |
Click here
|
| 2. Air conditioning amplifier |
Click here
|
|
| 3. Air conditioning control assembly |
Click here
|
|
| Temperature Control: No cool air comes out |
1. Refrigerant volume |
Click here
|
| 2. Refrigerant pressure |
Click here
|
|
| 3. Air conditioning pressure sensor |
Click here
|
|
| 4. Compressor and pulley (for 2AD-FHV) |
Click here
|
|
| 5. Compressor and pulley (for 2AD-FTV) |
Click here
|
|
| 6. Compressor and pulley (for 1AZ-FE) |
Click here
|
|
| 7. Compressor and pulley (for 2AZ-FE) |
Click here
|
|
| 8. Driver side air mix damper control servo motor circuit |
Click here
|
|
| 9. Passenger side air mix damper control servo motor circuit |
Click here
|
|
| 10. Evaporator temperature sensor circuit |
Click here
|
|
| 11. Room temperature sensor circuit |
Click here
|
|
| 12. Ambient temperature sensor circuit |
Click here
|
|
| 13. Expansion valve |
- |
|
| 14. Air conditioning amplifier |
Click here
|
|
| 15. Air conditioning control assembly |
Click here
|
|
| 16. ECM (for 2AD-FHV) |
Click here
|
|
| 17. ECM (for 2AD-FTV) |
Click here
|
|
| 18. ECM (for 1AZ-FE) |
Click here
|
|
| 19. ECM (for 2AZ-FE) |
Click here
|
|
| 20. LIN communication line |
- |
|
| 21. CAN communication system |
Click here
|
|
| Temperature Control: No warm air comes out |
1. Driver side air mix damper control servo motor circuit |
Click here
|
| 2. Passenger side air mix damper control servo motor circuit |
Click here
|
|
| 3. Air conditioning harness |
- |
|
| 4. Room temperature sensor circuit |
Click here
|
|
| 5. Air conditioning amplifier |
Click here
|
|
| 6. Air conditioning control assembly |
Click here
|
|
| 7. ECM (for 2AD-FHV) |
Click here
|
|
| 8. ECM (for 2AD-FTV) |
Click here
|
|
| 9. ECM (for 1AZ-FE) |
Click here
|
|
| 10. ECM (for 2AZ-FE) |
Click here
|
|
| 11. LIN communication line |
- |
|
| 12. CAN communication system |
Click here
|
|
| Temperature Control: Output air is warmer or cooler than set |
1. Driver side solar sensor circuit |
Click here
|
| 2. Passenger side solar sensor circuit |
Click here
|
|
| 3. Room temperature sensor circuit |
Click here
|
|
| 4. Air inlet damper control servo motor circuit |
Click here
|
|
| 5. Heater radiator |
- |
|
| 6. Expansion valve |
- |
|
| 7. Air conditioning amplifier |
Click here
|
|
| 8. Air conditioning control assembly |
Click here
|
|
| 9. ECM (for 2AD-FHV) |
Click here
|
|
| 10. ECM (for 2AD-FTV) |
Click here
|
|
| 11. ECM (for 1AZ-FE) |
Click here
|
|
| 12. ECM (for 2AZ-FE) |
Click here
|
|
| 13. LIN communication line |
- |
|
| 14. CAN communication system |
Click here
|
|
| Temperature Control: No temperature control (Only Max. cool or Max. warm) |
1. Driver side solar sensor circuit |
Click here
|
| 2. Passenger side solar sensor circuit |
Click here
|
|
| 3. Air conditioning amplifier |
Click here
|
|
| 4. Air conditioning control assembly |
Click here
|
|
| 5. LIN communication line |
- |
|
| No air inlet control |
1. Air conditioning control assembly |
Click here
|
| 2. Air inlet damper control servo motor circuit |
Click here
|
|
| 3. Evaporator temperature sensor circuit |
Click here
|
|
| 4. Air conditioning amplifier |
Click here
|
|
| Diagnostic trouble codes are not recorded. Set mode is cleared when ignition switch turned off |
1. Air conditioning amplifier |
Click here
|
| 2. Back-up power source circuit |
Click here
|