2005-2008 RAV4 · Service Manual BRAKE

Skid Control Buzzer Circuit

Circuit diagnosis · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

DESCRIPTION

The skid control buzzer sounds while the VSC is activated.

WIRING DIAGRAM

C194545E02

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on the intelligent tester (Click here).

    ABS/VSC/TRC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON / OFF
    Buzzer can be heard.

    OK:
    The skid control buzzer can be heard.



OK
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
NG


3. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Skid Control Buzzer Circuit (Aug 2007 – Jul 2008)TC and CG Terminal Circuit (Nov 2005 – Dec 2006) →