Home › TRANSMISSION ยท EB61F MANUAL TRANSAXLE › MANUAL TRANSAXLE SYSTEM

MANUAL TRANSAXLE SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Manual Transaxle System 
Symptom
Suspected Area
See page
Abnormal noise
Oil level (Low)
Click here
Oil (Wrong)
-
Clutch release with bearing cylinder assembly (Worn or damaged)
Click here
Clutch disc (Worn or damaged)*1
Click here
Synchronizer ring (Input shaft) (Worn or damaged)
Click here
Synchronizer ring (Output shaft) (Worn or damaged)
Click here
Gear (Input shaft) (Worn or damaged)
Click here
Gear (Output shaft) (Worn or damaged)
Click here
Bearing (Input shaft) (Worn or damaged)
Click here
Bearing (Output shaft) (Worn or damaged)
Click here
Bearing (Differential case) (Worn or damaged)
Click here
Oil leak
Oil level (High)
Click here
Gasket (Damaged)
Click here
Oil seal (Worn or damaged)
Click here
Clutch release with bearing cylinder assembly (Worn or damaged)
Click here
Hard shifting or impossible to shift
Oil (Wrong)
-
Clutch (Dragging)
Click here
Shifting system parts or selecting system parts (Worn or damaged)
Click here
Control cable (Faulty)
Click here
Shift fork (Input shaft) (Worn)
Click here
Shift fork (Output shaft) (Worn)
Click here
Synchronizer ring (Input shaft) (Worn or damaged)
Click here
Synchronizer ring (Output shaft) (Worn or damaged)
Click here
Shifting key (Input shaft) (Worn or damaged)
Click here
Shifting key (Output shaft) (Worn or damaged)
Click here
Gear (Input shaft) (Worn or damaged)
Click here
Gear (Output shaft) (Worn or damaged)
Click here
Hub sleeve (Input shaft) (Worn or damaged)
Click here
Hub sleeve (Output shaft) (Worn or damaged)
Click here
Jumps out of gear or shift lever moves excessively
Shift fork (Input shaft) (Worn)
Click here
Shift fork (Output shaft) (Worn)
Click here
Hub sleeve (Input shaft) (Worn or damaged)
Click here
Hub sleeve (Output shaft) (Worn or damaged)
Click here
Gear (Input shaft) (Worn or damaged)
Click here
Gear (Output shaft) (Worn or damaged)
Click here
Bearing (Input shaft) (Worn or damaged)
Click here
Bearing (Output shaft) (Worn or damaged)
Click here

HINT:
*1: If the clutch torsional damper springs are worn, they can produce a load-related noise similar to a bad bearing or gear rattle.