Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2012.12–2013.11
RM30B0U _57 Power Source / Network _009133 NETWORKING _0050933 CAN COMMUNICATION SYSTEM T

NETWORKING  CAN COMMUNICATION SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



Result List of How to Proceed with Troubleshooting
Symptom Suspected Area Link
Open in CAN Main Bus Line Open in CAN Main Wire Click here
Short in CAN Bus Lines Open in CAN Main Wire Click here
Short to +B in CAN Bus Line Short to B+ in CAN Bus Line Click here
Short to GND in CAN Bus Line Short to GND in CAN Bus Line Click here
Open in One Side of CAN Branch Line Open in One Side of CAN Branch Line Click here

HINT:

Refer to How to Proceed with Troubleshooting for the V Bus Check procedure.


The suspected communication stop area can be determined based on the ECU or sensor that was not displayed in CAN Bus Check and by referring to the table below.

Communication Stop Mode Table
Symptom Suspected Area Link
"Skid Control (ABS/VSC/TRAC)" is not displayed on Techstream Skid Control ECU Communication Stop Mode Click here
"Air Conditioning Amplifier" is not displayed on Techstream Air Conditioning Amplifier Communication Stop Mode Click here
"Power Steering (EPS)" is not displayed on Techstream Power Steering ECU Communication Stop Mode Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on Techstream Steering Angle Sensor Communication Stop Mode Click here
"ECM (Engine)" is not displayed on the Techstream ECM Communication Stop Mode Click here
"Main Body" is not displayed on the Techstream Main Body ECU Communication Stop Mode Click here
"Combination Meter" is not displayed on the Techstream Combination Meter ECU Communication Stop Mode Click here
"Certification (Smart)" is not displayed on the Techstream (w/ Smart Key System) Certification ECU Communication Stop Mode Click here
"Airbag" is not displayed on the Techstream Center Airbag Sensor Communication Stop Mode Click here
"Four Wheel Drive" is not displayed on the Techstream (for AWD) 4WD Control ECU Communication Stop Mode Click here
"Blind Spot Monitor Master" is not displayed on the Techstream (w/ Blind Spot Monitor System) Blind Spot Monitor Sensor Communication Stop Mode Click here
"Front Camera Module" is not displayed on the Techstream (w/ Lane Departure Alert System) Lane Departure Warning Camera Communication Stop Mode Click here
"Display and Navigation (AVN1)" is not displayed on the Techstream (for Radio and Display Type) Audio Receiver Assembly Communication Stop Mode Click here

DTC Combination Table
Symptom Suspected Area Link
Although CAN communication (V bus) is currently normal, ECUs connected to the V bus store CAN communication DTCs The probable part for which communication is interrupted can be determined using DTC Communication Table and comparing the DTCs output from ECUs connected to the CAN communication system Click here