Refer to DTC P0401.
Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>P0401
For more information on the EGR control, refer to System Description.
Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>SYSTEM DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P042E | Exhaust Gas Recirculation "A" Control Stuck Open | When EGR valve is determined to be stuck open for 5.7 seconds.
(1 trip detection logic) |
EGR valve assembly | Comes on | DTC stored |
Refer to DTC P0405.
Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>P0405
After replacing the EGR valve assembly, the ECM needs initialization.
Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>PRECAUTION
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Replace the EGR valve assembly.
Click hereEngine / Hybrid System>2WW EMISSION CONTROL>EGR VALVE>REMOVAL
Perform EGR learning value reset.
Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Turn the ignition switch off and wait for 60 seconds or more [A].
Perform road test [B].
Repeat [A] and [B] for the number of trips detected.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT